Nikon Binoculars 165 5x36 User Manual

(507B)/1E  
In the event that you should require service for your Nikon  
SlugHunter 3-9x40 Slug Gun Scope, in case of USA market, please  
send it directly to:Nikon Scope Service  
841 Apollo Street, Suite 100  
EI Segundo, CA. 90245-4721  
1-800-Nikon SV.  
In other market, please bring it to dealer from which you purchased it.  
SlugHunter 3-9x40/1.65-5x36  
Pour les autres marchés, veuillez apporter la lunette de visée au  
magasin où vous l'avez achetée.  
The Ultimate Slug Gun Scope  
Manufacturer:  
3-25, Futaba 1-chome, Shinagawa-ku, Tokyo 142-0043, Japan  
Tel:+81-3-3788-7697 Fax:+81-3-3788-7698  
Printed in Taiwan (507B)/3E  
Instruction manual/Mode d'emploi  
E F  
Congratulations on your choice of a Nikon Slug Gun Scope. Your new scope is the finest example of  
Nikon's rugged and durable construction and precision bright optics; important qualities for a  
serious shooter's Slug Gun Scope.  
3. Instructions  
(1) Focusing  
Whether you use your scope for hunting or for target shooting, the procedure for mounting is  
identical. You should acquire a set of high quality steel mounting rings which have a standard  
diameter of 25.4 mm (1 inch). Follow the ring manufacturer's instructions for mounting procedures.  
After mounting the scope on your Slug Gun, follow the procedures for reticle alignment.  
When setting the reticle for hunting, you should determine your standard range and then adjust the  
reticle based upon that target distance. For targets which vary from that standard distance you may  
simply adjust the position of the reticle in relation to your target, or you may wish to use the  
procedure for trajectory compensation. It's up to your personal preference.  
Look through the eyepiece with your eye positioned about 10cm (4 in) away from the  
eyepiece lens (Fig. 3-1), and you will see the Nikoplex reticle (Fig. 3-2), or the BDC200.  
Be sure your eye is positioned within proper alingment and proper eye relief otherwise the  
view will "black out".  
Point the objective end of the scope at the sky (Do not point at the sun) or at a plain  
unpatterned wall.  
Turn the eyepiece adjustment counter-clockwise and then turn it clockwise until the reticle  
appears sharp.  
(2) Magnification  
The SlugHunter 3-9x40 Slug Gun Scope has a variable magnification from 3 to 9X, 1.65-5x36  
from 1.65 to 5x. To change powers, just rotate the power selector ring until the desired  
magnification appears adjacent to the power index dot (Fig. 1-1).  
(3) Adjustment of the Slug Gun Scope  
We hope that you will enjoy your new Nikon Slug Gun Scope for many years to come. Enjoy using it,  
and above all, always follow safe shooting procedures!  
Caution  
(1) Do not look at the sun through the Slug Gun Scope. It will permanently damage your eye.  
This precaution applies to all optical devices such as cameras and binoculars.  
(2) The Slug Gun Scope is effectively sealed against moisture and dust. You may use your  
scope safely either in the rain or in dusty climates. To preserve the appearance of the scope,  
we suggest that it be dried and cleaned prior to storage. Use a soft cloth for cleaning metal  
surfaces and use photographic lens tissue to clean the scope's lenses.  
Sighting through the Slug Gun Scope, align the Slug Gun Scope with your aiming point on the  
target and shoot a trial round. If the bullet does not hit the aiming point, adjust the elevation and  
windage after removing the Adjustment cap, as follows:  
For the Slug Gun Scope adjustment is made by turning the grip by hand. If the bullet hits  
under the aiming point, turn the grip in the direction of the arrow marked "U" (Fig. 3-4). If the  
bullet hits to the left of the aiming point, turn the grip in the direction of the arrow marked "R"  
(Fig. 3-4).  
The product(s) described herein may be subject to export control regulations in the relevant  
country(ies). It (they) should not be exported without authorization of the exporting govermental  
authority if the regulations apply.  
(4) Zero setting of grip (Fig. 3-5)  
After the reticle has been adjusted to the point of impacts, with the grip held with your fingers to  
avoid shifting of the aligned grip, turn the grip screw in top of the grip counterclockwise with  
coin. Then lift the grip up and align the " " with the index mark. It may happen that the "  
"
could not align with the index mark exactly because of the coupling pitch of the grip with the  
shaft. And by securing the grip with your fingers to avoid shifting of the grip, turn the grip screw  
clockwise with the coin until the grip in firmly secured.  
1. Nomenclature  
Note:  
The windage and elevation scales of the Slug Gun Scope are calibrated in divisions of 1/4  
minute of angle with a click at intervals of 1/4 minute of angle.  
When adjusting the reticle to the point of aim, remember that one minute of angle equals  
approximately one inch (2.54 cm) at 100 yards (91.44 m). Therefore, if the impact point is  
two inches (5.08 cm) low and one inch (2.54 cm) right at 100 yards (91.44 m) Parallax  
Setting, you should adjust two minutes of angle up one minute of angle left.  
Fig. 1-1  
3-9x40  
1.65-5x36  
Magnified Figure of  
Hand turn Grip  
Maintenance  
(1) Lens cleaning  
To remove dirt or fingerprint, soak gauze or lens cleaning paper (silicon-free paper sold at  
camera shop) with a small quantity of absolute alcohol (available from drugstore) and lightly  
wipe off. Wiping with handkerchief of leather is not recommended as it is likely to damage the  
lens surface.  
Dust may scratch the lens surface or corrode the lens.  
Brush dust off using a soft oil-free brush.  
Objective Lens  
Eyepiece Lens  
Elevation Adjustment  
Windage Adjustment  
Eyepiece Adjustment  
Power Index Dot  
Power Scale  
(2) Scope Exterior  
Use a soft dry cloth to wipe off any dirt or finger-prints that might accumulate.  
It is not necessary to oil the scope's surface.  
(3) Windage/Elevation Adjustments  
These adjustments are permanently lubricated. Do not attempt to lubricate them. Cover with  
caps supplied, except when adjusting, to keep out dust and dirt.  
(4) Eyepiece Ajustment  
This adjustment is permanently lubricated. Do not attempt to lubricate.  
(5) Power Selector Ring  
Power Selector Ring  
Adjustment Cap  
Nikoplex Reticle  
Fig. 1-2  
Eyepiece Adjustment Eye Relief  
No lubrication is required on the power selector ring.  
Do not loosen or remove screws in power selector ring.  
Waterproof models:  
Fig. 3-2  
The Nikon Riflescope is waterproof, and will suffer no damage to the optical system if submerged or  
dropped in water to a maximum depth of 2 meters for up to 10 minutes.  
The Nikon Riflescope offers the following advantages:  
Fig. 3-1  
BDC200 Reticle  
Can be used in conditions of high humidity, dust and rain without risk of damage.  
Nitrogen-filled design makes it resistant to condensation and mold.  
Observe the following when using the Nikon Riflescope.  
2. Specifications  
As the unit does not have a perfectly sealed structure, it should not be operated nor held in  
running water.  
Model  
1.65-5x36  
3-9x40  
Any moisture should be wiped off before adjusting movable parts (Elevation / Windage  
adjustment knob, eyepiece, etc.) of the Nikon Riflescope to prevent damage and for safety  
reasons.  
Actual Magnification  
1.65x-5x  
3-9x  
Objective Diameter  
Exit Pupil  
(mm)  
(in)  
36  
1.42  
40  
1.58  
(mm)  
(in)  
7.2  
0.28  
4.4  
0.17  
Fig. 3-3  
To keep your Nikon Riflescope in excellent condition, Nikon Vision recommends regular  
servicing by an authorized dealer.  
Eye Relief  
(mm) 127.0-127.0  
127.0-127.0  
5.0-5.0  
 *�  
(in)  
5.0-5.0  
Field of View at 100yds.  
Tube Diameter  
Objective Tube Diameter  
Length  
(m)  
(ft)  
13.8-4.6  
7.7-2.6  
 *�  
45.3-15.1  
25.2-8.4  
(mm)  
(in)  
25.4  
1
25.4  
1
(mm)  
(in)  
45.3  
1.78  
49.3  
1.94  
(mm)  
(in)  
283  
11.14  
288  
11.3  
Weight  
(g)  
(oz)  
385  
13.6  
390  
13.8  
Adjustment Graduation  
1 click = 1/4" 1 click = 1/4"  
(moa)  
(moa)  
Maximum Internal  
Adjustment  
(Elevation & Windage)  
100  
60  
**�  
Parallax Setting�  
(at factory)  
(m)  
(yards)  
91.44  
100  
91.44  
100  
Fig. 3-4  
***�  
Outside Diameter of  
Eyepiece  
(mm)  
(in)  
42  
1.65  
42  
1.65  
Structure  
Waterproof (maximum depth of 2 meter  
for up to 10 minites) and Nitrogen Gas  
Fig. 3-5  
(at minimum magnification)-(at maximum magnification)  
**moa=minute of angle (in front of 100 yards one moa is nearly equal to one inch.)  
***Nikon riflescopes are factory set to be parallax free at 100 yards (91.44 m).  
 

Miele Washer W 872 User Manual
Miele Washer W 4802 User Manual
Mr Coffee Coffeemaker ECMP3 User Manual
Nextar MP3 Player MA177 User Manual
Nortel Networks Welding System P0919439 User Manual
NuTone Ventilation Hood 761WHNT User Manual
Olympus Microcassette Recorder LS 11 User Manual
Oregon Scientific Digital Camera PV 100 User Manual
Panasonic Fax Machine KX PW513DL User Manual
Panasonic Network Card MAS3132DG User Manual